Conveying Needle Inspection Machine Medicine Food Needle Metal Detector 150w

Needle tester

一,A machine used for testing
The working principle of the needle inspection machine is that first the upper and lower probes receive and process the signal, and then the strong electric integrated block, sensitivity control integrated block, signal receiving integrated block and signal output integrated block to complete the detection work.
When the goods through the needle test machine have broken needles or contain iron metal and other substances, the needle test machine is not allowed to pass, detected iron metal needle test machine will automatically alarm, and the conveyor belt back to the original position of the goods; The inspector can quickly find the location of the broken needle according to the location of the broken needle signal indicator light. Conversely, if no metal is detected, the commodity can pass through the needle inspection machine channel. In accordance with the regulations that the export textiles must pass the broken needle detection, the goods that pass the broken needle detection by the needle inspection machine can be exported.
二, Instruction and operating standard of needle test machine
The test instrument is a high precision test instrument, so the user must follow the following rules:
(一)Method of instrument movement:
1,Moving instrument method:
Select 4-6 strong men, stand on both sides of the machine, hands from the lower end of the two wings of the instrument, you can move the whole machine at will. Must not
A conveyor shaft that ends a conveyor belt by hand. Otherwise, the transmission shaft will be damaged, thus damaging the detection effect.
2,Push instrument method:
There are four steering wheels at the bottom of the instrument. When moving on the level, only two people need to stand on both sides of the instrument and use their hands to force towards the destination
Just push on. But it must not collide with other objects.
(二)Instrument placement requirements and methods:
1, the instrument can not be placed in the workshop with high voltage wires, so as not to be interfered by external current and radio waves.
2, instrument position above the fluorescent lamp, must be more than two meters away from the instrument plane, and the upper part of the instrument is best not installed fan (ceiling fan),
Also to avoid outside interference.
3. There are four support bolts at the bottom of the instrument, which play the role of horizontal balance support. Therefore, the four support pins must be levelled before use
Balance support. This can play an anti-interference role.